Reference
Version
Document
Lang.
Page
244-ENG
09-01-2018
244 DAN DRYER Turbo (with nozzle)
Maintenance and service manual
ENG
6 of 12
DAN DRYER A/S • Tåsingevej 2 • DK-8940 Randers SV • Tel: +45 86 41 57 11 • Email: [email protected]
Cleaning the inside of the machine
1.Disassemble cover by removing the two cover
screws at the bottom of the housing. Use the
special Allen key which was originally supplied
with the hand dryer.
Warning !!!
During cleaning and service the hand dryer must always be disconnected from the power supply.
Remove the
cover screws
Remove the
cover screws
3. Remove the four screws (B). Disassemble the
top half of the motor housing
(B)
(B)
(B)
(B)
4. Carefully lift up the motor whilst taking note
how the motor was positioned inside the
housing and how the motor wires are placed in
the protective grooves (C)
6. Check whether carbon brushes are worn down
and need to be replaced. If so, disassemble by
removing the screws and by disconnecting
wires from carbon brush terminals.
2. Disassemble angle bracket by removing the
screw (A)
(A)
5. Disconnect motor wires from the timer unit
(appearance depends on the timer type).
Place the motor on a table upside-down.
