Damani DOFF6.3SS Скачать руководство пользователя

Страница: 5 / 20

o Do not touch the appliance with damp or wet hands or feet.
o Do not pull on the power supply cable, or the appliance itself, to remove the plug from the mains power socket.
o Hot grease and fat catch fire easily. Be careful. Never try to put out burning oil or fat with water (danger of
explosion);
suffocate the flames with damp cloths.
o

The grill, hotplates and cooking containers will become extremely hot. Use protective gloves or hot pads.

WARNING: WE RECOMMEND USING ADEQUATE PREVENTION AND PROTECTION TOOLS WHEN

DISMANTLING, MAINTAINING AND CLEANING THE APPLIANCE.

o Do not use steam cleaners to clean the oven.
o When using or cleaning the oven, be careful not to place your fingers in the door hinges or in the door itself in
order to avoid crushing or injuries.
o Avoid cleaning parts of the appliance that are still hot.
o Painted, chrome plated and glass parts should be washed with warm water.
o The entire oven should be cleaned after each use with warm water and detergent, then rinsed and dried
thoroughly.
o The parts in stainless steel, and in particular the areas with engraving, must not be cleaned using abrasive
detergents or diluents. It is preferable to use only a soft cloth dampened with warm water or liquid dish
detergent.
o Denatured alcohol may be used to clean stubborn stains.
o Stainless steel may remain stained if it is in contact for an extended time with water which has excessive
mineral deposits or with aggressive detergents (containing phosphorus). After cleaning is finished, thoroughly
rinse and dry using a soft cloth.
o Avoid acidic liquids on painted or enamelled parts (vinegar, lemon juice, aggressive detergents, etc.)
o Do no use abrasive sponges or steel wool, muriatic acid or other items that could
scratch, streak, or lead to the glass in the door shattering.

CONNECTION TO MONO-PHASE ELECTRICITY

Ovens equipped with tri-polar power supply cables are constructed to function with alternating current, and with
the voltage and frequency indicated on the technical label on the appliance.

Assembly of the power cable:

1. Open the terminal board by placing a screwdriver
under the side flaps on the cover, pull and then open
the cover (see the figure).
2. Install the power supply cable, unscrew the screws
on the cablegrip and the three screws on contacts L-N-
and then attach the wires under the screw heads
respecting the colours Blue (N), Brown (L), Green
Yellow (see the figure).
3. Attach the cable to the appropriate cable holder.
4. Close the terminal board cover.

Attaching the power supply cable to the mains.

For direct connection to the mains power, it is necessary to use a device that ensures that the mains power is
disconnected, with a distance between contacts that allows complete disconnection in compliance with surge
category III and installation regulations.
Assemble a standard plug for the capacity indicated on the features typeplate.
If the oven has a direct connection to the mains electricity supply, it is necessary to install an omnipolar switch
between the appliance and mains power with a minimum opening between the contacts of 3 mm dimensioned
for the indicated capacity and in compliance with currently enforced regulations (the switch must not interrupt the
ground cable).
The power supply cable must be positioned in such a way that it does not exceed the room temperature by 50°C
at any point.
The installer is responsible for correctly hooking-up the electricity connection and adherence to safety
regulations.