daltile 816 BrS, Руководство по эксплуатации, Страница: 14 / 16

OPERATING INSTRUCTIONS
Single Step Cutting
DO NOT FORCE THE TOOL! It will do the job
better and safer at the rate for which it was
designed.
Use original Daltile ® wet cutting blades only.
●
Loosen the Adjustable Cutting Guide
retaining knob.
●
Position the Adjustable Cutting Guide to
desired cutting length.
●
Tighten the retaining knob.
Place the tile against the Ruler/Stop
and Cutting Guide.
●
Turn the motor ON.
●
Verify proper coolant flow on both sides of
the blade.
●
Perform the cut.
●
Turn the motor OFF when work is
complete.
Multiple Step Cutting
During this sawing process the saw is positio-
ned at the desired height and moved back and
forth through the material to be cut until after a
number of steps it is completely cut through.
●
Place the material to be cut on the sawing
table and position against the fixed stop
and eventually the adjustable stop.
●
Position the cutting head at the desired
height
●
Hold the material with one hand while
making sure your hand is free from the
cutting blade.
●
Perform the cut. This process must be
repeated until the material has been
totally cut through.
●
Turn the motor OFF when work is
complete.
45˚ Miter Cutting:
The Daltile® 828BrS Tile Saw is designed to
perform 45˚ Miter Cuts without additional tools.
●
Loosen the 2 handles on either side of the
machine.
●
Tilt the cutting head into the 45˚ position.
●
Fasten both handles.
●
Place the tile on the cutting table in the
desired position.
●
Hold the tile down with one hand. (Keep
hand away as far as possible from the
cutting blade)
●
Turn the motor ON.
●
Verify proper coolant flow on both sides of
the blade.
●
Perform the cut.
●
Turn the motor OFF when work is
complete.
PAGE 14
DALTILE 828 BrS OPERATING MANUAL V02/2004R1
Cutting Guide
Retaining Knob
828 28-10-2004 09:47 Pagina 14