daltile 1020 TS, Руководство по эксплуатации, Страница: 14 / 16

OPERATING INSTRUCTIONS
Cutting Straight Edges
DO NOT FORCE THE TOOL! It will do the job
better and safer at the rate for which it was
designed.
●
Loosen the Adjustable Cutting Guide
retaining knob.
●
Position the Adjustable Cutting Guide to
desired cutting length.
●
Tighten the retaining knob.
Place the tile against the Ruler/Stop
and Cutting Guide.
●
Turn the motor ON.
●
Verify proper coolant flow on both sides of
the blade.
●
Perform the cut.
●
Turn the motor OFF when work is
complete.
Single Step Cutting
(Use only original saw blades as advised by
the manufacturer)
●
Move saw head down until the saw is
approx. 3/8” below the saw table.
●
Secure saw head with the knob.
●
Place the material to be cut on the sawing
table and position against the fixed stop
and eventually the adjustable stop.
●
Hold the material with two hands while
making sure your hands are free from the
sawing blade.
●
Push the sawing table forward with control-
led feed so that the sawing blade is easily
cutting through the material.
Multiple Step Cutting
With this sawing process the sawing blade must
be adjusted to a desired cutting depth. The
material can be cut to the adjusted depth by
moving the sawing table forward and bac-
kward. This process can be repeated until the
material has been totally cut through.
●
Place the material to be cut on the sawing
table and position against the fixed stop
and eventually the adjustable stop.
●
Position the saw head at the desired height
●
Hold the material with two hands while
making sure your hands are free from the
sawing blade.
●
Push the sawing table forward with control-
led feed so that the sawing blade is easily
cutting through the material and move the
sawing table backward in its initial posi-
tion. This process must be repeated until
the material has been totally cut through.
45˚ Miter Cutting:
NOTE: To cut 45º Miters, the 45º Miter Guide
should be used.
●
Remove the Adjustable Cutting Guide.
●
Place the 45º Miter Guide on the Saw
Table and tighten the retaining thumb
screw. Position the tile on the 45º Miter
Guide.
●
Turn the motor ON.
●
Verify proper coolant flow on both sides of
the blade.
●
Perform the cut.
●
Turn the motor OFF when work is
complete.
PAGE 14 DALTILE 1020TS OPERATING MANUAL V02/2004R1
1020 22-07-2005 09:04 Pagina 14