Dalsa Piranha4 Series, Руководство пользователя

Страница: 20 / 95

20 Piranha4 8k Color Camera User's Manual
03-032-20274-00 Teledyne DALSA
Data connector: Camera Link
The camera uses two Camera Link SDR26 cables transmitting the Camera Link Base,
Medium, Full, or Deca configuration. The figure below shows the SDR26 Camera Link
Connector and the tables that follow list the Camera Link configurations.
For detailed information on Camera Link please refer to the Camera Link Road Map available
from the
Knowledge Center on the Teledyne DALSA Web site.
Figure 10. SDR26 Camera Link Connector
Data 2 Control / Data 1
Camera
Connector Right Angle
Frame Grabber
Connector
Channel Link
Signal Camera
Connector Right Angle
Frame Grabber
Connector
Channel Link
Signal
1 1 inner shield 1 1 inner shield
14 14 inner shield 14 14 inner shield
2 25 Y0- 2 25 X0-
15 12 Y0+ 15 12 X0+
3 24 Y1- 3 24 X1-
16 11 Y1+ 16 11 X1+
4 23 Y2- 4 23 X2-
17 10 Y2+ 17 10 X2+
5 22 Yclk- 5 22 Xclk-
18 9 Yclk+ 18 9 Xclk+
6 21 Y3- 6 21 X3-
19 8 Y3+ 19 8 X3+
7 20 100 ohm 7 20 SerTC+
20 7 terminated 20 7 SerTC-
8 19 Z0- 8 19 SerTFG-
21 6 Z0+ 21 6
9 18 Z1- 9 18 CC1-
22 5 Z1+ 22 5 CC1+
10 17 Z2- 10 17 CC2+
23 4 Z2+ 23 4 CC2-
11 16 Zclk- 11 16 CC3-
24 3 Zclk+ 24 3 CC3+
12 15 Z3- 12 15 CC4+
25 2 Z3+ 25 2 CC4-
13 13 inner shield 13 13 inner shield
26 26 inner shield 26 26 inner shield
Note
:
* Exterior Overshield is connected to the shells of the connectors on both ends. Unused pairs should be terminated in 100
ohms at both ends of the cable. Inner shield is connected to signal ground inside camera
Camera link bit definitions
Signal Configuration Remark
CC1 EXSYNC Keep this signal in low status when idle. The exposure time must not be
greater than the camera’s allowance— 3,000 µs.
CC2 Spare
CC3 Direction
CC4 Spare