HDD Mounting
4 www.dallmeier.com
►
Ensure that the HDD drawer unit and housing are flush.
►
Lock the HDD drawer unit with the key.
►
For the mounting of further HDDs proceed as described.
The mounted hard disk drives will be initilized and commissioned
with the start of the recorder.
►
Insert the HDD into the HDD holder.
►
Ensure that the HDD connections are positioned at the rear
side of the HDD drawer unit.
►
Mount the HDD with 4 screws.
►
Ensure that the recorder is disconnected from the
power
supply.
►
Unlock the HDD drawer unit with the key.
►
Pull the HDD drawer unit carefully out of the housing.
►
Remove the cover which is mounted in the HDD drawer unit.
►
Insert the HDD drawer unit into the guide rails.
►
Slide the HDD drawer unit carefully and completely into
the
housing.
►
Please pay attention that you do not cant.
►
Do not use force.
Requirements
Recorders that have been ordered with hard disk drive can directly be mounted, connected and commissioned.
Recorders that have been ordered without hard disk drive must be equipped with five 2.5" hard disk drives (Raid 5) at least.
Note that all mounted hard disk drives
must be tested and released for mounting by Dallmeier (HDD whitelist in the Partner Forum)!
may not be formatted or partitioned!
Depending on the number and the properties (capacity, new or used) of the mounted hard disk drives, various messages and
dialogues are displayed during the first start and the initialization.
►
Confirm the messages, if required.
►
Observe the instructions given in the dialogues.
►
Note the appropriate Configuration documentation.
►
Load the Default System Parameters as first step of the configuration.
IMPORTANT ADVICE
Mounting
The hard disks should be mounted in a row , starting with the slot for HDD1 (left, lower).
