dallmeier DDF4820HDV-DN, Руководство по установке и настройке

Страница: 26 / 103

DDF4820HDV-DN-IM/-SM
www.dallmeier.com 26
6.2 Surface Mount Variant (SM)
The housing base is mounted with 3 screws (Ø 4 mm) to the ceiling/wall.
You need:
•
T20 torx wrench
• Marking tool (e.g. awl)
• 3 mounting screws (Ø 4 mm)
•
3 anchors
• Electric drill
• Screwdriver

Unscrew the 3 housing screws ( Fig. 5-3 ) using a T20 torx wrench and remove the
housing.

Mark the drill holes on the ceiling/wall using the 3 pre-drilled mounting holes of the
housing base ( Fig. 5-4 ) as a template.

At the marked locations, drill holes fitting the screws/anchors to be used.

Push anchors suitable for the ceiling/wall material into the drill holes.

Run the required cables suspended from the ceiling/wall through a PG16 cable gland.

Screw the PG16 cable gland in the appropriate thread of the housing base.

Mount the housing base with 3 screws to the ceiling/wall.
Housing base
Mounting screw (Ø 4 mm)
Thread for
PG16 cable gland
Anchor
Drill hole
Ceiling/Wall
Ambient light sensor
Fig. 6-6

Connect the required cables to the connectors of the camera module
(see Fig. 5-5 and chapter “ Pin Assignment ” on page 98).

If necessary, connect a CVBS monitor to the video preview output ( Fig. 5-4 ).

If PoE (Power over Ethernet) is not available, first connect the camera to a suitable
power supply unit and then connect the power supply unit to the mains socket.

Align the camera with your scene using the 3-axis mount.