dallmeier DDF4010HDV, Руководство по установке и настройке

Страница: 24 / 107

DDF4010HDV
www.dallmeier.com 24
6.2 Surface Mount Variant
The housing base is mounted with 3 screws (Ø 4 mm) to the ceiling/wall.
Tools required for installation include:
• T20 torx wrench
• Marking tool (e.g. awl)
• 3 mounting screws (Ø 4 mm)
•
3 anchors
• Electric drill
• Screwdriver

Unscrew the 3 housing screws ( Fig. 5-5 ) using a T20 torx wrench and remove the
housing.

Unscrew the securing screws of the spring clips ( Fig. 5-7 ) and remove the plug-in mod -
ule while pushing the spring clips slightly together.

Mark the drill holes on the ceiling/wall using the 3 pre-drilled mounting holes of the
housing base ( Fig. 5-6 ) as a template.

At the marked locations, drill holes fitting the screws/anchors to be used.

Push anchors suitable for the ceiling/wall material into the drill holes.

Run the required cables suspended from the ceiling/wall through a PG16 cable gland.

Screw the PG16 cable gland in the appropriate thread of the housing base ( Fig. 5-6 ).

Connect the required cables to the connectors of the terminal area in the housing base
(see chapter “ Pin Assignment ” on page 97).

Mount the housing base with 3 screws to the ceiling/wall.
Ceiling/Wall
Drill hole
Anchor
Mounting screw (Ø 4 mm)
Fig. 6-6