DALGAKIRAN TIDY 20B-50, Руководство оператора, Страница: 63 / 157

6
2. CHAPTER
INSTALLATION & ASSEMBLY
2.1 INSTALLATION OF THE COMPRESSOR AND CONNECTIONS
9 The floor on which the compressor is mounted should be capable of carrying the weight of
compressor and should be flat and dry. There is no need to fixing (anchorage bolt etc) to the floor.
9 The compressor room should be easily accessible and sufficiently illuminated.
9 For adequate service, the compressor room should have a clearance of at least 1.5 m from ceiling
and 1m from the wall.
9 Fire and corrosion causing conditions should be prevented in the operation region.
9 No pipe load (swaggering connections or tensions arise from environmental variations) should be
relayed to compressor by external connections.
9 Make sure that the air supply equipment is suitable to the operating pressure of the piping and
fittings and is damage free.
9 Select the diameter of the air supply, dryer and line filters according to your air supply capacity. (It
is beneficiary to select piping of big diameter considering future development of your company).
9 Establish a separate line for condense discharge of your filter and dryer and air tanks (water
discharge line); this way the floor of the compressor operating place does not unnecessarily get
wet.
9 Put an air exit and electric box in your compressor room for general purpose
9 Your compressor is manufactured for indoor operation.
9 In case of different needs in relation to compressor or air supply contact service or sale
representative.
2.2 COMPRESSOR ROOM VENTILATION
9 In order to maintain the operation temperature at a specific value, place your compressor at a
place that adequate air flow is provided. The temperature that compressor operates should be at
least 2 and at most 40 °C. Do not place your compressor where the temperature is less then + 2
°C and if necessary heat the compressor room.
9 If you think that there will not be sufficient amount of air flow in the room of operation; it is
necessary to make room ventilation or you must discharge the outgoing hot air the compressor to
outside. When doing this, the outgoing hot air of compressor should not return. For this reason the
hot air outlet and room air inlet should not be on the same side.
AIR INLET
HOT AIR OUTLET
HOT AIR
OUTLET
AIR INLET
9 When making duct at the compressor’s hot air exit, the most important thing is ,duct should not be
narrower then the dimension of compressor hot air outlet cowling and it should not be long or curly
to cause resistance.