DALEMANS sa/nv
Rue Jules Mélotte 27A
B-4350 Remicourt
+32 19 33 99 43
U•V6
Instruction Manual
39
|
65
Certified
ISO9001 • VCA
The
Analogue Output Info
sub-menu allows the user to view the settings for the analogue
output of the U•V6 unit.
When the user makes a selection using the
ENTER
key, they can view the settings for the
analogue output in the U•V6 unit.
Type
[X
. .
XX mA]
Factored-in channels
Gain detector status configuration. Only visible if the
analogue output has been enabled
Gain
[X : 1]
Gain configuration. Only visible if the analogue output
has been enabled
The
Up
and
Down
arrow keys allow the user to view the gain type that has been configured
in the U•V6 unit for each detector.
a)
Current-Mode Configuration
Current Mode includes three settings, with the following possible configurations:
▪
Disabled
: the circuit connected to the analogue output is not active
▪
0-20mA
current loop
▪
4-20mA
current loop
b)
Channels Factored into the Calculation of the Output Signal
The
Factored-In Channels
sub-menu allows the user to select the measurement channels
that are taken into consideration when calculating the analogue output signal.
The calculation in question is a
maximum value
from among the channels measurements
that are taken into account.
When the user makes a selection using the
ENTER
key, they can view the gain status of the
detector
, whether it is enabled or disabled, in the U•V6 unit.
The user can use the
Up
and
Down
arrow keys to view the list of detectors, along with their
respective statuses, in the U•V6 unit.
1. Detector x
Factored in / Disabled
This sub-menu is only visible if the analogue output has been enabled.
a)
Output Gain
The
Gain
sub-menu allows the user to view the additional gain ratio for the analogue output.
By default, it is set to 1 (no effect).
