1
DAX 3F-I
Introduction
These instructions must be read carefully by any person who has or will have the responsibility for
the installation, the use and/or the maintenance of this equipment. The warranty provided by
DALEMANS will be voided if installation, use and maintenance of this equipment are not in accor-
dance with the instructions given in this manual.
By respecting these instructions you guarantee the correct operation of the apparatus. Should you
require any further information about the use or the maintenance of this product, do not hesitate
to contact Dalemans PRIOR to carrying out installation works.
Each apparatus must be installed, operated and maintained according to the instructions, the
warnings and the operational limits detailed in this manual.
Use only DALEMANS original parts when you assume the maintenance of this product as specified
in this manual. The use of non-Dalemans spare parts may seriously impair the performances of the
apparatus. Repair or maintenance attempts carried out without observing the procedures
described in this manual or without the assistance of our after-sales service may prevent the
equipment from working properly and, consequently, from ensuring the safety of the occupants
of the building and of the plants.
!
Always make sure to switch off power and declassify the hazardous area before
carrying out replacement or modification works on components of the gas
detection system.
Application
The
DAX 3F-I
gas detector is suitable for use in hygienic and/or aggressive areas of industrial and
commercial environment. This apparatus is intended for use in explosive atmospheres of hazard-
ous areas (zone 1 or 2). The
DAX 3F-I
is designed to operate as part of a fixed gas detection system
and to provide, in association with a suitable control unit, early warnings of flammable gas hazard
before gas concentration reaches the Lower Explosive Limit (LEL).
For further information about the detectable gases or the list of the compatible control units,
please contact Dalemans.
Approval - Standards
As a manufacturer, Dalemans Company declares that the product described in this manual is certi-
fied for hazardous areas with an ingress protection degree IP6X and that it fulfils the requirements
of the following directives and standards :
• Directive 94/9/EC (ATEX)
• EN 60079-0:2006
• EN 60079-1:2007
• EN 60079-7:2007
• EN 61241-0:2006
• EN 61241-1:2004
The said products comply with the acceptable variations originating from the type that has
received the EC-Type Examination Certificate Nr FTZU 10 ATEX 0034X. Moreover, they have been
designed, manufactured and controlled within the framework of an ISO9001 certified quality
assurance system which has been assessed by a notified body according to annex IV and VII of the
Directive 94/9/EC.
