DALBO FRONTFLEX, Руководство пользователя, Страница: 7 / 22

FRONTFLEX
Side 7
Hitching and Unhitching
The FRONTFLEX is manufactured in compliance with DS/ISO 730-1 category II. The
arms of the front lift must be rigid, preventing them from moving sideways. If the
front lift of your tractor is not suitable, please contact your DALBO distributor.
Hitching
Mount the lift arms into the hitch points (A, Fig. 1). Next, install the top link. Adjust
the top link so that the main frame of the FRONTFLEX is in a horizontal position and
parallel to the ground. Raise the implement, allowing the parking stands (
front and
rear
) to clear the ground and placing the implement in an operating position.

Remember to secure the lift arms and top link with lynch pins.
Fig. 1
Lift arm tilt angle
With the FRONTFLEX in an operating position, the lift arms (B) should be tilted at an
angle preferably a couple of degrees above horizontal of the direction of travel or at
least horizontal. This angle will enable the FRONTFLEX to roll over any obstacles, as
the tractor presses the implement tilted upwards and the steering will be simulta-
neously maintained. (Steering can be made even easier if the top link is shortened,
so that the main frame points a few degrees upwards in the front.)
Mounting behind tractor
The FRONTFLEX can be mounted in the three-point hitch on the rear of the tractor if
needed.
A
B