Daktronics Sportsound Rack SSR-100, Руководство по эксплуатации

Страница: 15 / 32

Setup & Operation 11
Wireless Mic & Bodypack Operation
1. Open the battery cover. Insert new or fully-charged AA batteries prior to each use, and always have
spares on hand.
2. Power on the transmitter device ( Figure 17 ).
3. Hold the transmitter device up close to one receiver in the rack, ensuring the infrared (IR) windows
are aligned.
4. Press sync on the receiver; “good” will display if sync was successful.
5. Repeat steps 1-4 to pair another transmitter device with an additional receiver (if present).
Note: Plug the referee mute switch into the jack on top of the bodypack unit and plug headphones/
lapel mic into the referee mute switch.
Verify Reception: With a transmitter and the receiver both turned on and having matching GROUP and
Channel numbers, the RF meter on the receiver should be indicating signal. Speak into the microphone and
the TX AUDIO meter should indicate signal presence.
Additional Tips:
• Perform a group and channel scan to obtain the best available channel for microphones.
• Check that battery levels are adequate to prevent wireless equipment from powering off during use.
• Program one microphone per receiver; multiple microphones on the same channel will cause
interference and microphones will drop out.
• Always use quality batteries to prevent battery leaks that can corrode and shorten the life of the
equipment.
Power IR Window
a
e
b c
d
g
f
h
Power
ON/OFF
Power
ON/OFF
IR Window
Figure 17: Wireless Mic & Bodypack Controls