Daktronics P1192, Руководство по установке

Страница: 8 / 34

120 VAC Trumpet Horn Installation
4
2 120 VAC Trumpet Horn Installation
Reference Drawings:
Wiring Guide; Gyrus Outdoor Horn Kits .......................................................... DWG-3068821
Refer to DWG-3068821 in Appendix A for general wiring details of LED scoreboard horns.
The following section describes the 120 VAC trumpet horn installation for an LED
scoreboard. Assemblies are only available for 120 VAC scoreboards.
Note: Disconnect power to the scoreboard before installing the horn!
Equipment
The trumpet horn kit consists of:
• a horn
• a metal mounting angle
• a horn interface card and harness
• assorted #10 screws, tapping screws, and nuts
Location
The horn entrance panel is typically located in the center of the lower half of the
scoreboard (refer to the component location drawings included in the scoreboard
manual for specific location). The horn will be mounted directly to this entrance panel.
The panel may be secured only by screws, or it may have hinges to swing open.
Basic Horn Installation
• If the horn kit was ordered with the scoreboard, the horn interface card, mounting
angle, and horn body were likely installed at the factory; follow the simple instructions
below.
a� Locate the horn entrance panel as described in Location (p�4) .
b� Locate and screw the trumpet part of the horn into the horn body through the 2"
knockout on this panel.
• If these components have not been installed, skip ahead to Complete Horn
Installation (p�4) .
Complete Horn Installation
Horn Interface Card Installation
Reference Drawings:
Horn Card Installation; Gyrus Driver ................................................................ DWG-3067686
• Current 120 VAC horn card part number: 0P-1192-0399
Attach the horn interface card inside the scoreboard driver enclosure and make the
proper wiring connections from the horn interface card to the driver per DWG-3067686 .