Daktronics GEN VI RADIO P1110, Руководство по установке

Страница: 8 / 34

Setting Radio Channels
4
3� The radio receiver listens for a sever on the following channels, in order:
a� B# C## - the exact channel the radio is set to via its switches
b� B# C00 – the broadcast channel
c� B0 C00 – the master broadcast channel
d� Diagnostics Channel – see Radio Diagnostics (p�10)
e� The sequence then repeats.
4� The receiver searches until a server on one of those channels is detected. The DATA
OUT indicator (red LED) will flash periodically while searching.
5� Once locked onto a server, the RADIO IN RANGE indicator (amber LED) illuminates.
The radio will remain on that channel until the server is removed, powered down, or
the client is powered down.
Note: Refer to DWG-1109105 (indoor) or DWG-1109181 (outdoor) for instructions on
changing the channel and broadcast groups inside the radio receiver.
Figure 3 shows the LED indicators on the radio receiver.
• POWER (green LED) – Illuminates when power is applied to the receiver
• RADIO IN RANGE (amber LED) – Illuminates when a server (radio-equipped console) is
active on the receiver’s broadcast group channel
• DATA OUT (red LED) – Randomly flashes when data is being received from a server;
regularly pulses when searching for a server
2.4GHZ
LL-2567
REV 01
POWER
RADIO IN RANGE
DATA OUT
DAKTRONICS
WIRELESS RECEIVER
Status Indicators
Remove Cover to
Access Switches
Figure 3: Radio Receiver w/ Cover