Daktronics Galaxy AF-3400 Series, Руководство пользователя

Страница: 21 / 93

Mechanical Installation
2-3
2.5 Display Mounting
Reference Drawing:
Shop Drawing, Mounting Details.................................. Drawing B-227417
The method used to mount displays can vary greatly from location to location. For
this reason, only general mounting topics can be addressed in this manual.
It is the responsibility of the installer to ensure the installation will adequately
meet local codes and standards, including the mounting hardware and method
.
Before beginning the installation process, verify the following items:
•
The mounting structure will provide a straight and square-mounting frame
for the display –
height variation in any four-foot horizontal section may
not exceed 1/4-inch.
•
The mounting structure will not give way at any unsupported points after
the display is mounted.
The back of the display is equipped with 2 x 2 x 3 x 1/4" steel clip angles at the
locations shown in
Drawing B-227417 for your display size. These angles may be
used for mounting purposes. Remember to have all mounted displays inspected by a
qualified structural engineer.
Refer to the appropriate
Drawing B-227417 for a suggested wall mount method. The
number of attachment points needed and the wall structure must be reviewed by a
qualified structural engineer and meet all national and local codes. It is the
customer’s responsibility to determine the proper wall mounting method and
location. Daktronics requires using all clip angles or mounting holes as attachment
points
.
Mounting a Non-Sectional Display
1. Carefully uncrate the display and inspect each side of the display for
possible damage that may have occurred during shipping.
2. If mounting a sectional display, refer to the segment following this
sequence.
3. Following the guidelines described in Section 2.4 , lift the display into
position on the support structure.
4. Weld or use 1/2" Grade-5 bolts and hardware to secure the clip angles to the
support structure as shown in the
Drawing B-227417 for your display.
5. Refer to Section 3 for information on routing power to the display and the
communication manual for routing the signal.
6. After installation is complete, carefully inspect the display for any holes
that may allow water to seep into the display and seal any openings with
silicone –
if the eyebolts on the top of the display have been removed,
plug the holes with bolts and the flat washer that was removed with the
eyebolt (unless there is an overhead structure).