Quick Guide: Digit Display Installation with FLR 1500 Control Kit
5 of 5
Multi-Client Radio Installations
If you would like additional client radios, note the following conditions:
•
Each client radio must be in direct line-of-site with the server radio.
•
Each client radio must have the J2 jumper in the closed position.
•
All radios must be set to the same address.
•
The signal strength on the server will not be available in multi-client mode because the strength will be
different for each client radio.
For additional information on using the hand-held controller, refer to the display manual.
Outdoor J-box Installation
1.
Choose a location for the j-box on the support pole that is
easily accessible for plugging in the hand-held controller.
Figure 9: Outdoor J-Box Installation
2.
Securely attach the j-box to the chosen location. Mounting tabs
may be attached to the back with provided screws, if that
attachment method will be used.
3.
Choose wether to run the RJ14 cable out the top, back, or
bottom of the j-box. Insert a ¾” conduit fitting in the chosen
knockout.
Note:
Signal and power need to be routed to the sign in
separate conduit.
4.
Remove the faceplate assembly by taking out the two screws.
Plug the RJ14 cable into the jack behind the faceplaten (
).
5.
Replace the faceplate assembly in the j-box by reinstalling the
two screws.
6.
Run the RJ14 cable through conduit or the sign pole and into
the host display driver. Plug the end of the RJ14 cable into the
driver’s Signal IN jack (J13) (
,
B
). Grease the signal
jack (J13) with electrical contact grease before making the
signal connection.
PO Box 5128 201 Daktronics Dr Brookings SD 57006-5128
tel 605-697-4036 or 800-325-8766 fax 605-697-4700
www.daktronics.com
DD1399086 Rev 2
12 April 2010
