background image

All Sport 5000 Series Console Quick Guide

DD2077845
Rev 03
01 August 2018

201 Daktronics Drive

Brookings, SD 57006-5128

www.daktronics.com/support

800.325.8766

Page 4 of 4

Jacks & Switches

• 

J1, J2, J3 (SCOREBOARD OUTPUTS)

 – These 1/4" stereo jacks 

connect directly to fixed-digit scoreboards, clocks, and statistic 

displays. All 3 jacks send out the same scoreboard control signal. 

Note: 

These jacks may not be needed for wireless systems. 

Wireless consoles sold 

after May 2016

 feature a radio 

antenna in a protective shell on the side of the console. 

Wireless consoles sold 

before May 2016

 have a radio 

antenna connected to the rear of the console;  

ensure antenna is pointed straight up during operation

• 

J4 (MAIN CLOCK START/STOP/HORN SWITCH)

 – Connect a main 

clock handheld start/stop switch here. 

J4

 may also be used for 

external Precision Time console (for basketball). 

• 

J5 (COMPUTER PORT)

 – 

Not used on this model 

• 

J6 (I/O PORT)

 – This jack is the main input and output port used 

to send data to multiple displays (scoreboard, play clock, and 

locker room clocks), communicate with other All Sport consoles, 

and send Real-Time Data (RTD) to Daktronics display controllers. 

• 

J7 (PLAY CLOCK START/STOP/RESET SWITCH)

 – Connect a play 

clock handheld start/stop/reset switch here. 

• 

J8 (SWITCH INPUTS)

 – 

Not used on this model 

• 

S1 (POWER)

 – Power the console ON/OFF. 

Important Safeguards

•  Always turn off and/or unplug the control equipment when it is 

not in use. Never yank the power cord to pull the plug from the 

outlet. Grasp the plug and pull to disconnect. 

•  Do not drop the control console or allow it to get wet. 
•  Do not let the power cord touch hot surfaces or hang over the 

edge of a table that would damage or cut the cord. 

• 

If an extension cord is necessary, use a three-pronged, polarized 

cord. Arrange the cord with care so that it will not be tripped 

over or pulled out. 

• 

Before using an extension cord, inspect the cable thoroughly and 

verify its compliance with local electric codes. 

•  Do not disassemble control equipment or electronic controls of 

the display; failure to follow this safeguard will make the warranty 

null and void. 

•  Inspect console for shipping damage such as rattles and dents, 

and verify that all equipment is included as itemized on the 

packing slip. Immediately report any problems to Daktronics; save 

all packing materials if exchange is necessary. 

Отзывы: