Manual # 650380A
3. Using the provided screws and lock washers; attach the Speed and Tach instrument panels to the
stock instrument housing.
4. Install the Clock instrument panel between the Speed and Tach installed in Step 3, again
using the provided screws and lock washers.
5. Plug the supplied 24
” cable in to the Tach port, and connect it to the left Speed port. Also plug in the
supplied turn-signal harnesses if stock turn indicators if desired.
This system comes with the option to use two sets of turn signals in your dash: arrows located in the faceplate of your new
VHX display, and arrows in your vehicle’s stock turn signal locations. To use the new faceplate arrows, follow the wiring
instructions for the turn signals found in the main VHX manual.
To optionally use the stock turn signal arrows, do not wire the turn signals to the VHX control box. Instead, use the two (2)
provided two-wire harnesses. The harnesses plug directly into connectors on the back side of your new VHX system.
Connect the wires from these harnesses to your turn signal circuits and ground as shown below. Doing this will emit green
LED’s located in the stock locations of your dash panel; when turn signals are active. Make sure to check left and right to
verify they were wired correctly.
