6
MAN#650477:D
GAUGE SETUP AND CALIBRATION
The function switch is used to enter setup mode for all of the gauges. All of the setup is done from the
speedometer message display. To get into setup, press and hold the function switch while turning the key on. Press and
release the switch to advance through the menus below, when on the desired option press and hold the switch to select
setup for that particular gauge/function.
SPEEDOMETER SETUP
Main Menu
Sub Menu
Description
Diag CODE
engine
Read diagnostic codes from engine module
Secure
Read diagnostic codes from security module
Abs
Read diagnostic codes from ABS module
COLOR
ALL
Set all colors and brightness the same
BACKLIGHT
Set backlight color and brightness
NEEDLE
Set needle color and brightness
DISPLAY
Set message display color and brightness
SPEED
ADJUST
Adjust speed calib/- 40%
UNIT
Select MPH or km/h unit
SERVICE
Set miles to service reset value or turn off
ODO PRESET
One time odometer preset
(only available once for the first 100 miles)
TACH
HI WARNING
Set high rpm warning point
OIL TEMP
on/off
Enable/Disable option oil temperature reading
SENDER
Select temperature sender type and unit
WARNING
Set high warning point
TEST
Display sender resistance for troubleshooting
OIL PSI on/off
Enable/Disable option oil pressure reading
WARNING
Set low warning point
FUEL
SENDER
Select fuel sender
RANGE
Enable/Disable/Reset distance to empty
light
Enable/Disable/Adjust low fuel indicator
TEST
Display sender reading for troubleshooting
VOLTAGE
LO WARNING
DISPLAY CONTRAST
Message center contrast adjustment
PRFM DISP
Display performance readings
MBMS
Show MB
M’s connected to the speedometer and set warning points
GEAR
LEARN
Learn gears based on speed and RPM
PRESET
Set gears based on factory setup
DONE
Exit
