MAN #650776
6
Operation, Clock Set, Service Reset
FUNCTION SWITCHES
The two switches built into the face of the gauge allow you to make adjustments to the gauge. During normal
operation, the function switch allows access to information including mileage, RPM, and performance data located
within the 4 outer display locations. The left switch controls the left display, the right switch controls the right display.
When you press the switch, an arrow is shown on the display indicating which message location is currently selected,
or in focus. Tap the switch to scroll through information available in each location.
If you would like to change focus to another location
MOVE LINE
RELEASE TO MOVE
l be displayed below; if the data in
the selected location can be reset, such as a tripmeter, the bar will be emp
HOLD TO CLEAR
above. Release the switch before the bar empties and the next line of information will be in focus, illustrated by arrows
on each side. Focus alternates top and bottom.
To clear or reset information such as Trip A, Trip B or performance readings, press and hold the function switch until
you see the status bar filling. Continue to hold the switch as the bar em
HOLD TO CLEAR
RELEASE
played above the status bar. The information will now be reset.
If the function switch is pressed while the key is in the off position, the clock and odometer will be displayed.
SETTING THE CLOCK
The clock uses a 12 hour format and can be set with the key on by holding the function switch while the focus arrow is
next to the clock. If the clock is not shown, tap the function switch until it appears; keep in mind you may need to
move to another message location.
RELEASE
yed; the hours will begin flashing. Tap switch to change the hours, hold the
switch to move to the minute set and the minutes will begin flashing. Tap the switch to change the minutes; hold the
switch to save and exit the clock set mode.
SERVICE RESET
The screen will go back to the last display shown.
To clear the service odometer, after your service was completed, press and release the function switch until
the highlighted
appears in either message location.
