9
MAN# 650666:A
DISPLAYS Message display option menu
Refer to graphic on
page 3
for indicator and message locations.
•
When
“>DISPLAYS” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
•
The display will
show “MESSAGE TOP”, “MESSAGE BTM”, “MBMs”, or “BACK”.
•
Press and release the switch to change the selection,
press and hold the switch until “RELEASE” is displayed, and release.
MESSAGE TOP Top message screen information
•
When
“>MESSAGE TOP” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
•
The selectable options are
“PERFORM HIDE”, “PERFORM SHOW”, and “BACK”.
•
Push and release the switch to select the option,
press and hold the switch until “RELEASE” is displayed, and release.
•
PERFORM HIDE: does not allow any performance option displays to be show while riding.
•
PERFORM SHOW: turns all the following options that can be toggled through while riding.
o
HIGH Speed (MPH
– km/h), 0-60 time, ¼ mile speed with ¼ mile time, and HIGH RPM.
•
Press and release the switch to change the change the option.
•
Press
and hold the switch until “RELEASE” is displayed, and release.
•
Exit setup.
BTM MESSAGE Bottom message screen information
•
When
“>MESSAGE BTM” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
•
The selectable options are
“PERFORM HIDE”, “PERFORM SHOW”, and “BACK”.
•
Push and release the switch to select the option,
press and hold the switch until “RELEASE” is displayed, and release.
•
PERFORM HIDE: does not allow any performance option displays to be show while riding.
•
PERFORM SHOW: turns all the following options that can be toggled through while riding.
o
HIGH Speed (MPH
– km/h), 0-60 time, ¼ mile speed with ¼ mile time, and HIGH RPM.
•
Press and release the switch to change the change the option.
•
Press
and hold the switch until “RELEASE” is displayed, and release.
•
Exit setup.
MBMS Display which MBMs are connected and adjust warnings
If a pressure or boost sensor is not connected or
failed, the display will show “FAIL”, “TOO LOW”.
If no MBM is attached but the display shows a blank value, click through the displays to remove it.
•
When “>MBMs” is displayed, press and hold the switch until “RELEASE” is displayed, and release.
•
The screen display what MBM modules are attached and more than one input if it exists.
•
The screen will show “NONE” if there are no MBMs present.
•
Press and release the switch to move through the MBMs attached.
•
Press and hold the switch
until “RELEASE” is displayed on the MBM setting to modify.
o
See the separate MBM manual for additional details.
•
Exit Setup.
