Dakota Digital MCL-3K-A, Руководство пользователя

Страница: 5 / 6

Manual # 650300:C
GAUGE SETUP
The air pressure gauge has a user selectable high and low pressure warning point that can be set
so the gauge will flash the reading when the pressure is out of range.
The GREEN switch input wire, in the two pin connector, is used to enter setup. If you are only
installing one or a couple Dakota Digital MCL-3K gauges set up may seem a little strange since they are
designed to work as a set, however you’ll simply cycle through a few screens to get to the desired gauge.
The table below shows what will be on the gauge with each button press, or tapping the GREEN wire
high +12V.
Speed Tach Oil psi Oil temp Fuel Volt Air Pres
1
st
      
2
nd
      
3
rd
      
4
th
      
5
th
      
6
th
      
7
th
      
8
th
      
Please note that the word “switch” in the setup instruction is in reference to the GREEN wire, you
can install any momentary push button switch and use that or simply strip the wire back and hold or tap
the GREEN wire to a +12V source for set up. Once setup is complete, cover the end of the GREEN wire
and secure it so it cannot accidentally be shorted.
To enter setup:

Press and hold the switch while turning the key on, the gauge should light an
d show “  xx” (xx is
the software code and may be used for tech support).

Release the switch and “

” should be displayed. Looking at the table, above, press and
release the switch and scroll through until you see
“  ” on the display; this is the screen you
need to get to in order to enter the air pressure setup.

Press
and hold the switch until “  ” is displayed, release the switch and the current sender
selection will be displayed.

Press and release the switch to toggle from “  ” for SEN-1031(0-150 psi) or “  ” for SEN-
1035(0-400 psi).

When the desired sensor is displayed press and hold the switch until “  ” is displayed to set a
low pressure warning point. Press and release the switch to toggle through to the desired low
pressure.

Press and hold when the
desired low point is selected until “  ” is displayed. Press and release
the switch to toggle through to the desired high pressure warning point.

When the desired high pressure value is displayed press and hold the switch until “  ” is
displayed.

Pres
s and release the switch to toggle from “  ” for a slower, averaged reading on the gauge or
“  ” for a faster update, less averaged reading.

When the desired update rate is displayed, press and hold the switch until “  ” is displayed to
save changes.

Turn off key. Setup is complete.