6. Insert each new LED assembly through the hole where the original bulb and connector were.
Use caution when feeding the wires through to avoid damaging the wire insulation.
7. Feed the wires through the large hole in the back plate and attach the back plate onto the back
side of the housing. The flat side of the mounting disk should be toward the outside and the
side with the slight raised center should go in toward the housing. This will index the mount in
the original housing.
8. Secure the LED assembly into the housing with the supplied plate and nuts.
9. Place the original lens gasket into place and replace the tail light lens.
10. Cut off the existing light socket as it will not be used. Trim the wires from LED assembly to
appropriate length, once mounted, making sure wires are routed cleanly and securely.
11. Use the supplied moisture resistant pigtail connectors*** to attach the wires from the new LED
assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and
mating LED assembly wire into a connector and crimp following instructions below.
***For the best connection, soldering is recommended. But to simplify installation the supplied connectors will
provide a fast weather resistant connection.
