Dakota Digital GPS-50-1, Быстрый старт

Страница: 2 / 6

2 MAN #650398:B
Dakota Digital display data usage
The speed outputs can each be used in place of a separate transmission connection to the gauge control unit. The clock
is based on the accurate GPS time and only the hours need to be set to match it to your time zone. The compass
requires no setup or calibration for the vehicle and is accurate any time the vehicle is moving. The altimeter is calculated
from the GPS position data to give your current elevation. Each of these can be individually turned on or off.
The compass and altimeter may not display correctly unless the gauge control has the following firmware version or
higher:
VFD3: SE46
VFD3X: SE55
VHX: C VX04.009 (control box firmware must end in
“.009” or higher)
D V***.006 (display firmware must end in
“.006” or higher)
The compass, clock, and altimeter will be displayed in the message center.
Using speed from the GPS-50-1 without a BIM-01-1 connected

Make sure the BIM units are all connected to the gauge control box with the supplied 3.5mm data cables.

Hold the SW1 switch from the gauge system control box while turning the key on. The message display should
show SETUP.

Release SW1. The message display should show SPEED.

Press and hold SW1. The message display should show SENDER. Release SW1.

Press and release SW1 until BUS is displayed.

Press and release SW1 until DONE is displayed.

Turn the key off.

Next, press and hold the switch on the GPS-50-1 while turning the key on. The GPS-50-1 display should show
the current software revision.

Release the switch. The display should show “  ”.

Press and hold the switch until “  ” is displayed.

Release the switch. The display should show “SPD”.

Press and hold the switch until “  ” is displayed.

Release the switch. The display will show the current setting.

Press and release the switch u
ntil “ON” is displayed.

Press and hold the switch until “  ” is displayed.

Turn the key off.
Using speed from the GPS-50-1 with a BIM-01-1 connected

Make sure the BIM units are all connected to the gauge control box with the supplied 3.5mm data cables.

Hold the SW1 switch from the gauge system control box while turning the key on. The message display should
show SETUP.

Release SW1. The message display should show SPEED.

Press and hold SW1. The message display should show SENDER. Release SW1.

Press and release SW1 until NORMAL is displayed.

Press and release SW1 until DONE is displayed.

Turn the key off.

Next, press and hold the switch on the GPS-50-1 while turning the key on. The GPS-50-1 display should show
the current software revision.

Release the switch. The display should show
 ”.

Press and hold the switch until “  ” is displayed.

Release the switch. The display should show “SPD”.

Press and hold the switch until “  ” is displayed.

Release the switch. The display will show the current setting.

Press and release the switch until “OFF” is displayed.

Press and hold the switch until “  ” is displayed.

Turn the key off.

Connect the GPS-50-1 SPEED 1 terminal to the gauge control box SPD SND terminal.