- 13 -
650014B
ANCHORING CRUISE CABLE (CONTINUED)
4. The FLAG NUT may also be used to anchor the CRUISE CABLE
using the CABLE BRACKET.
CRUISE HARNESS
A.
Push Rubber Grommet securely into place on the cover of the CRUISE
MODULE.
B.
Straighten the CRUISE HARNESS and find the 2- & 4-pin mating connectors. Separate the 2- & 4-pin connectors. A
small screwdriver may be needed.
C.
CRUISE HARNESS needs a 19mm (.75”) hole to pass through bulkhead.
You may find one nearby, such as the speedometer cable hole or a small
one you can file larger. If you find the right size hole in the right place,
remove vehicle grommet. If not, drill a 19mm hole in bulkhead. A hole a few
millimeters to the left or slightly
NOTE : Check inside before drilling, sawing, or filing so you don’t damage
anything.
D.
From engine side, pass the 2-& 4-pin connectors through hole. If you do not hook up the Dark Blue TACH wire and
the Gray VSS wire under the hood, pass them through to the inside of the vehicle, also. Reattach the 2-& 4-pin mating
connectors and make the necessary wire connections.
SEALING BULKHEAD
Seal hole in bulkhead with SEALING PUTTY to avoid moisture from getting inside the vehicle.
