[4]
MAN #650541:A
STEP BY STEP CONNECTIONS
Connecting OBDII cable [J1]
The CRC-1000 can only be used in US made engine/drive trains running SAE CAN bus, 2008 and newer.
The OBDII harness connects direct to the OBDII diagnostic plug. The OBDII harness will need to be removed
from the ALDL port, if engine diagnostics needs to be performed with a scan tool.
In some cases, the CAN High + and CAN Low - wires could be soldered direct to the OBDII harness.
This will allow for the OBDII port to remain open, or be used by a Dakota Digital BIM-01-2.
SAE CAN bus uses pins 6 and 14.
Cut the large plug off and
solder
the Red wire to pin 6 and the Black wire to pin 14
