The following pages of the manual show some common applications and how to wire relays to
the CMDX outputs. These are only suggestions and other relay configurations are possible
depending on your application or device to be driven.
DOOR AND TRUNK LATCH WIRING.
Latches and latch actuators are not included in the kit. These are available separately. If door
motors or solenoids are already mounted in the vehicle, the CMDX system can be used to
control them.
All outputs need to be wired through an external relay.
Latch motors and
actuators also need to be connected to a
momentary
output, NEVER hook a latch actuator to
a latching output or motor damage could result. All of the relays in Figure 2 are connected to
‘A’ outputs, or momentary outputs to ensure the latch motor is only powered while a button is
pressed. Holding a button for an extended period of time could also damage latching motors.
FIGURE 2
Door and trunk latch wiring diagram.
FIGURE 3
Wiring to control actuator with the remote and an inside switch.
5
