MAN #650587A
System Setup:
EFI system setup
This unit is plug-and-play. Attach the included Y-harness to your FAST EFI. No further setup is required.
Display data usage
The following readings can each be used in place of dedicated sending units to the gauge control unit. These are
individually selectable in the display system gauge setup menus.
*Some gauge features require a minimum software revision or higher to be supported:
Oil Pressure
VHX
VX04
VFD3
SE47
VFD3X
SE55
VHX/VFD Setup:
Using speed from the BIM-01-2
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display should
show SETUP.
•
Release SW1. The message display should show SPEED.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
Using RPM from the BIM-01-2
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display should
show SETUP.
•
Release SW1. Press and release SW1 until TACH is displayed.
•
Press and hold SW1. The message display should show T CAL or ENGINE. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
Using engine temperature from the BIM-01-2
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display should
show SETUP.
•
Release SW1. Press and release SW1 until WATER is displayed.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS F or BUS C is displayed depending on your unit choice.
•
Press and hold SW1 until DONE is displayed.
Using oil pressure from the BIM-01-2 (if available)
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display should
show SETUP.
•
Release SW1. Press and release SW1 until OIL is displayed.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
***Intake/manifold air temp, Fuel PSI and A/F ratio will be displayed in the message center if activated through the display
menu setup.
