CODING THE RECEIVER:
1. The SBB-4000 can send a signal to any of the Dakota Alert
4000 series receivers.
2. Please refer to your receiver manual for coding instructions of
your particular receiver.
3. To activate the SBB-4000 to send a signal to your receiver, either break the
beams while they are paired or quickly press and release the power button
on the
“A”
sensor. A signal will be sent to the receiver for code learning.
4. If coding more than one set of beams to a receiver, repeat steps 2 and 3 for
each additional pair of beams.
SETTING REMINDER SIGNAL FOR CONTINUOUSLY
INTERRUPTED BEAMS:
1. If the beams are continuously interrupted, the
“A”
sensor will send a
reminder signal to the receiver. The factory default is to send a signal
every 20 seconds if the beams are continuously interrupted.
2. To change the reminder duration to 5 minutes, press and hold the power
button of the
“A”
sensor for 5 seconds then release. The LED will
start flashing red.
3. To change back to the 20 second reminder duration, press and hold the
power button of the
“A”
sensor for 5 seconds then release. The LED will
now flash green.
4. After you are finished pairing, coding, and setting the reminder time,
insert the rubber plugs into the holes near the power button on both the
“A”
and
“B”
side. To ensure that water does not enter the beams during
outdoor use.
Power Button of
“A” Unit
Be sure to re-insert rubber plug
before mounting permanently
