ONLY OPEN UNIT ‘A’ IF CHANGING THE ZONE/CHIME IS ABSOLUTELY NECESSARY.
It is not recommended to change any settings as the BBA-2500 is factory set to match.
DO NOT OPEN UNIT ‘B’.
Remove the 8 screws on the back
of unit ‘A’ (Figure 5-1). Gently
lift the solar panel to expose the
transmitter board (Figure 5-2).
Locate the 10 dip switches on
the red block. The first eight dip
switches are for the frequency
setting (256 combinations). Set
switches 1-8 to match the eight
switches in the receiver. Switches
9 and 10 are for the zone/channel
settings on the transmitter.
The four zones are listed in the table below.
CODING THE DCR-2500 RECEIVER:
Open the receiver case by inserting a small
screwdriver into one of the pry notches on the side
of the case (refer to receiver manual). Gently lift off
the front cover. Locate the eight dip switches on the
DCR-2500 and make sure they are set identically to
dip switches 1-8 on the BBT-2500.
Note: If more than one transmitter is used with the
receiver, the first eight dip switches of all transmitters
must match the eight dip switches of the receiver.
Note: Whenever a change is made to the time jumper or the dip switches, the receiver must be
turned OFF and then back ON to operate properly.
Switch 9 Switch 10
Channel
Tune
On
On
1
Classical
Off
On
2
Westminster
On
Off
3
Ding Dong
Off
Off
4
Whistle
