Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
10
REV022019
WORK STOP ADJUSTMENT
1) Loosen the thumb screw (item 38) holding the work stop casing (item 41) to the shaft.
2) Adjust the work stop casting to the desired length.
3) Rotate the work stop as close to the bottom of the cut as possible.
4) Tighten thumbscrew.
CONTROLS
CHANGING FEED RATE
Located on the front right of the saw is the adjustment for the feed rate as well as the down feed
lock. To slow the feed rate, turn the knob clockwise, counterclockwise causes the feed to
increase. Feed can be adjusted 0-10, 0 being no feed pressure causing the saw to fall the
fastest. At 10 the highest feed pressure, causing the saw to fall the slowest at this setting.
To lock the saw head in an elevated position, turn the handle so that it is perpendicular with the
feed cylinder. To unlock and resume down feed, turn the handle back parallel with the cylinder.
See figure below.
