Dake LAGUNA 14CX, Инструкция по эксплуатации

Страница: 11 / 37

14CX 11 REV#072023
MACHINE ASSEMBLY
For instructional video follow link: https://www.youtube.com/watch?v=6zrMJ1aCrgI
Or scan the QR code!
1. After making sure there is no damage to the outside of the packaging, proceed to open packaging
and inspect internal contents for damage.
2. Remove all components from box, starting with this manual. Box contents include: user manual,
fence, fence knuckle, hardware, cast iron table and the main saw assembly. NOTE: lift assist with
cast iron table = 50lbs.
3. Remove packaging from main saw assembly, make sure to get all of the loose Styrofoam.
4. In the hardware kit locate rubber feet along with hardware (shown above). Install with hex T-bar.
NOTE: Optional mobility kit available: “MBA14/12 Wheel System”.
Follow link for installation video:
https://www.youtube.com/watch?v=ldImqjeTBgw&ab_channel=LagunaTools
a. Support the bandsaw on wooden blocks.
b. Fit the swivel assembly to the back of the bandsaw with the provided bolts.
c. Fit the front wheels to the front of the bandsaw with the bolts provided and remove the two
rubber feet that are close to the front wheels.
5. Carefully stand the saw upright on a flat, level surface.
6. Unwrap the bottom side of the table (ungreased side) and inspect the 2 bolts on the underside of
the table, make sure they can pivot freely in their slots.
7. With assistance lift and flip over the table so that these 2 bolts line up with the 2 holes on the table
mount.
8. Check to make sure the bolts are all the way through before releasing table top. In the hardware
kit locate 2 washers and 2 adjusting handles. Add the washer followed by the adjusting handle.
Tighten on adjusting handle by pushing the button and turning the hub that extends out when
button is pushed. After tightened let go of button and use handle to lock in table tilt.