SETUP
MOVE METHOD
Make sure that the backrest is in its highest upright position.
Shut off power and remove the power plug from the wall outlet.
Standing behind the back of the chair, grasp its backrest and tilt it downward, so
that the front of the chair rises off of the floor. Push the chair to the location you
desire.
Do not attempt to move the chair while someone is still sitting on it.
While moving the chair, always grasp its backrest. No not try to move the chair by
grasping its armrests.
Before plugging it in, inspect the entire power cord and plug for any possible
damage. Make sure that no electrical wires are exposed.
Make sure that the power supply switch is turned OFF before inserting the power
plug into a wall outlet.
CAUTION
SETUP
Plug of the heater
Air tube connector
Air tube
Zipper
6. Installing the back cushion and buffering cushion
7. Installing the seat cushion
8. Other connections
Affix the back cushion and buffering cushion to the backrest of the chair with zipper.
To install the heater onto the back cushion, locate the connections on the pillow and
the waist air tube (see illustration below).
Use tape to fasten the lower portion of the back cushion to the seat cushion.
Place the seat cushion onto the seat shelf, and attach the air tube connector.
Use tape to fasten the seat cushion to the seat shelf.
Locate the cord attached to the controller and connect it to its corresponding port on
the power supply box.
Place the controller onto the tray.
Insert the power plug of the chair into a wall outlet, then turn on power to return the
chair’s backrest to its upright position.
