E
E
●
Programme the chanel code by pressing the “0” and “1” push but-
tons as shown:
Warning: if, during programming, you leave more than 7 seconds
between entries or if you do not press “0” and “1” at the same time
or for long enough, you will quit the programming mode: the red
light flashes, the programming is incorrect. Start the customising
procedure again from the beginning.
●
To test the channel code, press the “1” push button for a few
seconds: the medallion light indicator comes on for 2 seconds and
then goes out.
❍
The control panel responds with a series of two-tone audible
signals: “Beeep-bip, beeep-bip, beeep-bip,...” and the light indicator
corresponding to the chosen channel comes on.
❍
The telephone dialer responds with a high pitched beep.
If this does not happen, start the medallion customisation proce-
dure again after checking the series of “0” and “1” for the installa-
tion code and channel.
Note for control panels equipped with a radio reception light indi-
cator: although the medallion has the Dual Frequency technology,
it is normal that the radio reception light indicator does not come on
when the medallion is used.
●
Put the control panel in the normal mode and carry out a real test.
Check the reaction of the control panel (or telephone dialer interfa-
ce) using the following table.
If the control panel (or telephone dialer interface) responds as
described above, the medallion implementation procedure is com-
plete.
FIG. F
Closing
➊
Place the medallion cover sliding part opposite the base rail and
press to fit the two parts together.
➋
Slide the cover on the base until the medallion case is comple-
tely closed.
The medallion is now ready to use.
INDICATION OF LOW BATTERIES
The batteries are low when the light indicator only comes on faint-
ly or not at all. In this case, see your local dealer.
GB
11
GB
10
Channel
Reaction of the control panel in the test mode
Alert Call
2-tone audible message and the Alert light indicator
flashes
Silent Alarm
2-tone audible message and the Silent Alarm light indicator
flashes
Audible Signal
2-tone audible message and the Batteries light indicator
flashes
Press both keys at the same
time until the light goes out.
The light then comes on again
for 5 seconds to indicate
successful programming.
0
1
0
1
Press both keys
at the same
time until the
light goes out
Start customising
End of customising
Type the series
of 2 keys
corresponding to
the channel code
{
{
{
0
1
Press both keys
at the same
time until the
light goes out
{
Chanel
Response of the control
Reaction
Reaction of the
panel in the normal mode
of the sirens
telephone dialer
Alert Call
The integrated siren is
Sounded
Alert terminal
sounded for 90 secs and
for 90 secs
connection is
the alarm is memorised
activated for 1,5 sec
Silent Alarm
No reaction.
No reaction
Prog. 1 or Prog. 2
The Silent Alarm
terminal connection
is memorised on
is activated
control panel
for 1,5 sec
Audible Signal 4 audible beeps
No reaction
No reaction
and no memorisation
www.absolualarme.com met à la disposition du public, via www.docalarme.com, de la documentation
technique dont les références, marques et logos, sont la propriété des détenteurs respectifs
