19
GB
18
GB
■
For programming this example, carry out the following sequence:
The Prog. key
is programmed for the Alert Call when you
take it out of its packaging.
You can choose to program one of the functions described in the
table.
Attention, this choice must be carried out according to the type of
control panel used.
Some of the control panel do not react to all these functions (you
can refer to the installation guide of the control panel).
■
For programming the key Prog., carry out the following sequence:
If you make a mistake, the red indicator light will flash.
Repeat the procedure from the beginning.
Selecting programmable options
Function
Reaction of the system
Alert call
Triggers all means of alert (sirens, telephone dialer
interface,...)
Silent alarm
Triggers telephone dialer interface only, without the sirens.
This use is particularly suited to the protection of the ill or
aged people
Audible signal
Triggers an audible beep on the control panel
Light
Activation of 230V command receiver
. . .
1.
Start
programming
by pressing
both keys
simultaneously
until the indicator
light goes out
3.
Start
programming
by pressing
both keys
simultaneously
until the indicator
light goes out
2.
Enter the
sequence
of
8 short key
presses
corresponding
to the selected
function
4.
Press
the
Prog.
key.
The light then
comes on again
for 5 seconds to
indicate successful
programming
Key presses
1
2
3
4
5
6
7
8
9
10
Personalised radio code
x
x
x
Remote control code
Key presses
1
2
3
4
5
6
7
8
9
10
Personalised radio code
Remote control code
The installation radio code is coded by programming
■
Use the personalised radio code selected for the control panel.
On the “remote control code” line sketch beneath each
cross
the
symbol
corresponding to the
“Off”
button.
■
Complete the empty slots by sketching the
symbol corres-
ponding to the
Total Arm
button.
You now have a series of
and
symbols corresponding to
the programming code.
■
Program the radio code by pressing the keys on the detector as
indicated below:
If you make a mistake, the red indicator light will flash.
Repeat the procedure from the beginning.
Ex. (not to be used): you have chosen the connections 2, 7 and 8.
You now have a series of
and
which is the code to be
entered on the remote control.
Programming the personalized radio code
3.
Confirm the programming
by pressing both keys
simultaneously until the indicator
light goes out. The indicator light
will come on for 5 secondes
to indicate the programming
has been successful
1.
Start
programming
by pressing
both keys
simultaneously
until the indicator
light goes out
2.
Enter the
sequence
of
10 short key
presses
corresponding to
the personalised
radio code
. . .
Содержание DP1612
Страница 12: ...23 22...
