Folded flap
to roll up
Pool blanket
Roller & Tube
Locate roller at opposite end of extended area - Fold over to roll up.
Tips to Save your Daisy
1)
Whenever the cover is rolled up on
the roller, ensure that the overcover is in
place.
2)
To prevent damage to your cover,
do not drag the cover over abrasive pool
decking or any sharp surfaces.
3)
Excessive temperatures can
damage your cover. Ensure that
your pool does not reach excessive
temperatures.
4)
Most dirt and debris can be hosed
orswept into your skimmer box. If you
have a large amount of debris on top
of your cover, a broom or brush can be
used to sweep it into a pile for removal.
Water and a soft brush are all that is
required to remove heavier grime.
5)
Before storage your cover should be
thoroughly hosed both sides to remove
any of the pool chemicals.
When storing your solar pool cover, it
can not be subjected to the sun. Store
in a completely covered environment.
6)
When rolling up the cover onto
the roller, ensure that it rolls up evenly.
Always use your overcover whenever
your cover is on the roller.
7)
Test your water regularly to maintain
correct chlorine levels. Your cover
will deteriorate quicker when you
have excessive chlorine. When super
chlorinating, leave your cover off the
pool for 48 hours. This allows your
chlorine level to come back to normal.
8)
Roll your cover over the top of your
roller when using.
9)
Fold in any flaps or step areas on
the cover before rolling it up. This will
ensure that you don’t put excessive
force on the cover and allows it to move
easily.
10)
When putting the cover back onto
the pool, roll the cover out slightly, fold
one corner over onto itself (to create a
bow effect), pick up the other corner
and walk slowly down the side of your
pool.
(see cover image)
11)
Do not sit or step on your roller.
If the tube gets bent, it can not be
repaired.
12)
Monitor your chemical levels to
maintain correct balance.
13)
When using your roller, ensure that
the brakes on the castors are locked.
14)
If a storm is imminent, roll up the
cover and store it safely.
OverCover
Once installed cover & roller
are easy to move away.
Every roller comes with a
Free Daisy OverCover.
Right - Overcover used
when cover not on the pool.
ANY
pool cover can be ruined in less
than
HALF
of it’s predicted life span.
95% of all warranty claims are not
caused by product failure, but by owner
abuse, caused by:
A)
Leaving a cover rolled up out in the
direct sunlight while off the pool.
OR
B)
Having excess chlorine in the pool
(either a little too high over a prolonged
period or a lot too high over a very short
period)
Either of these may
VOID YOUR WARRANTY
To ensure the effective life of your pool
cover please:
1 -
Ensure that your chlorine levels
never exceed 3ppm.
(Chlorine is a corrosive agent and
actually wears the cover) and please
do not assume that your salt-water
chlorinator can control chlorine levels in
your water.
TEST YOUR WATER REGULARLY.
2 -
Ensure that you take the cover off
(and leave it off for 48 hours) when
super chlorinating.
3 -
Never leave the cover folded or
rolled up in the sun. It must be in full
shade. (Not under shade cloth)
This will cause the cover to be damaged
in strips across the cover and will cause
delamination,also the sun and heat will
cause corrosive wear.
4 -
Do not cover the blanket with a
tarpaulin or anything other than the
recommended cover type.
This material will reflect the sun’s rays
while many others will absorb them.
5 -
When storing the cover ensure
that it has been washed on both
sides with fresh water before storage.
This does not apply if you are replacing
the cover within 24 hours. This prevents
the chlorine residue from burning the
cover.
6 -
If you have a roller ensure that
you place the white overcover
(supplied with the roller) over the
cover every time you roll up the
cover, even if the swim is only for 10
minutes, as this is enough time to
destroy the cover.
Overheating on the roller will
cause delamination in strips across
the cover and in extreme cases can
cause the material to become
molten and weld itself to itself
Defective material or workmanship on
a pro-rata basis as set out on the back
page. The manufacturer will repair or
replace the product upon inspection at
their premises.
WITHOUT PROPER CARE
