DAISHIN SRM180K
Page 12
MAINTENANCE OPERATION TOBE CARRIED OUT BY THE USER
BEFORE perform any maintenance operation on the machine, cut off the engine, and remove
the sparkin wire from the sparking plug
If maintenance operation are not realized, damages can occur to the machine and personnal injuries
to the user and/or spectators. These damages and injuries will not be covered by the warranty.
• Daily maintenance will be performed by the user.
• Maintenance opérations for first 20 hours, 100 et 300 should be realized by the dealer.
• Ask your dealer to check the machine if you meet some problems.
• Ask your distributor the name of your dealer.
D
AILY MAINTENANCE,BEFORE START MOWING
Oil level : check by the gauge (A figure 9). Oil level should appear in the middle of the window. when
the gauge is put on his place without screwing it (figure 13). Check only engine stopped since ten
minutes on a flat level surface.
• Use only good quality gear oil 80W90 API GL4.
• Ask to your dealer to change oil once a year.
F
UEL
(Figure 10, repère 1)
Check tank level is full before start to work. Check that tank cap is fully closed, and check for leaks.
Use only a good quality unleaded gasoline.
Check fuel tank is closed, wipe fuel spillages before start the machine. Check there is no fire,
electric sparks, cigarettes near the machine when refuelling.
T
IRES
Check tires are not cutted, cracked or worn.
• Check tires pressure : 1,2 bar front and 1,4 bar rear.
S
AFETY STICKERS
• Check safety stickers are sticked at their place. Replace
them if they are worn and damage.
B
LADE AND BLADE HOLDER CONDITION
You can be cutted and injuried by cutting blade. Always wear gloves when holding blades.
Check rotary blades are in good condition, change worn or damage parts.
Changing blade : unscrew hexagonal screws and washer from the blade holder.
Check the blade condition. Change it if it is worn bend or crackle.
Check thightening of hexagonal screws according to the chart at the end of the manual.
Sharpen as shown in C, follow the angle of 30-40°, keep a sharpen hedge of 0,4 to 0,6 mm.
Always keep 30 mm of width.
