Daimler Freightliner Cascadia 2021, Руководство пользователя

Страница: 91 / 322

Automatic Headlights
If the vehicle is equipped with a rain-light sensor and
the headlight switch is in the ’A’ position, the low
beam headlights and all exterior lights activate when
the outside light decreases to a pre-set level. See
Fig. 4.2 .
Auxiliary High Beam Lights
If present, auxiliary high-beam lights are located in
the front bumper. To activate the auxiliary high beam
lights, press the upper part of the dash switch. The
auxiliary high beam lights will illuminate only when
the high-beam headlights are on. They will switch off
temporarily when the low-beam headlights are on,
until the high beams are on again. Press the upper
half of the switch to deactivate the auxiliary high
beam lights. See
Fig. 4.3 .
Backup Lights
Backup lights activate only when the vehicle is in re-
verse, and are designed to be used while backing up
at night.
Daytime Running Lights
If the vehicle is equipped with daytime running lights
(DRL), they are automatically activated when the ig-
nition is switched on and the parking brake is re-
leased. The DRL turn off when the engine falls below
400 rpm, the parking brake is applied, or the head-
lights are turned on.
Daytime running lights are mandatory for vehicles
domiciled in Canada. Vehicles domiciled in any other
location may have an optional override switch
(
Fig. 4.3 , ref. 3). This is a momentary switch that en-
ables the driver to deactivate the DRL.
Fog Lights
Fog lights are designed to reduce glare in foggy con-
ditions. The marker lights or headlights must be on in
order to turn the fog lights on. Pull the headlight
switch outward to activate the fog lights.
Hazard Warning Lights
The hazard warning light switch is located on the
dash switch panel. See
Fig. 4.4 . The hazard lights
can be activated regardless of the ignition switch
position.
To activate the hazard lights, press the center of the
switch once. The switch will blink at the same rate
that the hazard lights flash. Press the switch again to
turn them off. All the turn signals on the vehicle and
trailer, as well as the turn signal indicators in the
ICU, flash simultaneously when the hazard lights are
activated.
Headlights & Follow Me Home Feature
The headlight switch is a rotary switch located to the
left of the steering column, above the ignition switch.
See
Fig. 4.2 .
If the Follow Me Home feature is activated, the low-
beam headlights will remain on for nine seconds
after the vehicle is parked, if the headlights were on
prior to engine shutdown. This feature provides tem-
porary lighting in the path of the headlights while
walking to a building or other destination. If a vehicle
door is opened or closed while this feature is active,
the timer will add an additional 10 seconds of light-
ing. This feature can be temporarily disabled by turn-
ing the ignition switch on, or by cycling the headlight
switch from the off position to one of the other two
positions.
Some vehicles may have a feature that automatically
turns on the headlights if the windshield wipers are
on and the vehicle is moving faster than 10 mph (16
km/h). At speeds between 10 and 40 mph (16 to 64
km/h), cycling the headlight switch will turn the head-
lights off.
f611525 08/28/2018
1
2
3
4
5
1. Fog Lights (optional)—Activate by pulling the switch
out when the marker lights or headlights are on.
2. Automatic Headlights
3. Off
4. Marker Lights
5. Headlights
Fig. 4.2, Headlight Switch
Driver Controls
4.2