10
(2) Lay the wires in the el. compo. box through the wire inlet on
the side of the el. compo. box.
•
Do not lay the remote controller wiring or transmission wiring
along with the power supply wiring or other electric wiring in
the same route. Separate the remote controller wiring and
transmission wiring at least 50 mm from the power supply
wiring or other electric wiring, or otherwise malfunctions or
failures may be caused by external electric noise that may
interfere with the remote controller wiring and transmission
•
wiring.
For the installation and wiring of the remote controller, refer
to the remote controller installation manual provided with the
remote controller.
•
•
For power supply wiring, refer to the wiring diagram as well.
Be sure to connect the remote controller wiring and transmis-
sion wiring correctly to the right terminal block.
Low-voltage wiring inlet
Transmission wiring
(Low voltage)
Remote controller wiring
(Low voltage)
High-voltage wiring inlet
Power supply wiring (High voltage)
!
Earth wiring (High voltage)
(3) Follow the instructions below, and lay the wires in the el.
compo. box.
Trim and lay the wiring neatly and attach the el. compo. box
lid securely.
An electric shock or fire may result if the el. compo. box lid
catches any wiring or the wires push up the lid.
(4) Put the el. compo. box lid, and wrap the wire sealing
material (Small (9)) around the wires in order to block the wire
through holes.
•
After all the wiring connections are done, fill in any gaps in
the through holes with putty or insulation (procured locally) to
prevent small animals and insects from entering the unit from
outside. (If any do get in, they could cause short circuits in
the el. compo. box.)
(5) Mount the provided wire fixing bracket (10) with the wire
fixing screw (11). Fix each wire with the provided clamp (7).
[Precaution s for Power Supply Wiring]
•
Connect round crimp-style terminals provided with insulation
sleeves to the terminal block for power supply.
Be sure to follow the instructions provided below if the specified
terminals cannot be used.
Other wise, abnormal heat may be generated as a result of the
loo sening of the wires.
Wire through holes
Power supply wiring
Earth wiring
Transmission wiring
Remote controller wiring
Fixing use
Wire fixing bracket (
1
0
)(accessory)
Wire fixing screw (1
1
) (accessory)
Clamp (7) (accessory)
Electric wire
Round crimp-style terminal
Attach insulation sleeve
Connect the
wires evenly.
Do not connect a
wire to the single
side only.
Do not connect wires
different from each
other in diameter.
!
CAUTION
!
WARNING
!
CAUTION
Never connect the power
supply wiring.
PROHIBITED
Transmission
wiring
(NO Polarity)
Remote controller
wiring (No polarity)
Connection method of remote
controller terminal (X2M)
• If stranded wires are
used,do not solder the
front end of the wire.
L
N
GROUND
Transmission wiring
(Low voltage)
Remote controller
wiring (Low voltage)
Power supply wiring
(High voltage)
Earth wiring
(High voltage)
(K1S)
(T1R)
X1M
X2M
RED
WHITE
L
N
15
18
BLUE
(LOW VOLTAGE)
RED
(HIGH VOLTAGE)
Fix the wire with
clamp
(7) to the
wire fixing
bracket
provided to the
el. compo. box.