12
Read First
English
4
Preparing the water tank
(for Humidifying operation)
1.
Take out the water tank and remove the cap.
Remove while
pressing
Water tank
Cap
2.
Fill the water tank with tap water and close the
cap.
Attention
Do not pour any of the following into the water tank.
• Warm water (40ºC or above), aroma oil, chemical
agents such as hypochlorous acid, unclean water,
water containing aromatic substances or detergent,
etc.
These may cause deformation of the unit or
malfunction.
• Water from a water purifi er, ionized alkaline water,
mineral water, well-water etc.
These may lead to the propagation of mould or
bacteria.
• Perform in a place where spilling water will not cause
a problem.
• Clean the water tank by shaking a small amount
of water inside before fi lling up the water tank
with water.
• For maintenance procedures refer to
►
Page 28
.
Securely tighten the cap on the water tank.
If not done, water leakage could result.
Water can be
fi lled right up to
the neck
Tighten securely.
Note that even if
tightened securely and
completely, the screw
threads will still be
slightly visible.
• The water tank will be heavy when fi lled with water.
Hold the water tank fi rmly with both hands when
carrying.
• Avoid touching the valve in the centre of the cap.
Water in the water tank will leak.
•
After tightening the cap, turn the water tank upside
down (so that the cap faces downward) and check
for any leaks.
Valve
[Viewed from below]
Do not touch the valve
in centre of the cap
3.
Put the water tank in the unit.
• Hold the grip and fi t the water tank into the humidifying
tray.
1
Insert
2
Fully press below
until you
hear a catching sound
Water tank
Humidifying tray
Attention
As leaving any residual water in the humidifying
tray will lead to bad odours and dirt build-up, be
sure to discard any residual water in the
humidifying tray each time the water tank is refi lled.
If there is a bad odour or dirt, refer to
►
Page 29
.
