Daikin MC707VM-S, Руководство по эксплуатации

Страница: 16 / 19

15
/ English
Care and Cleaning
„ „ „ „ Cleaning the deodorization catalytic unit
• Vacuum dusts with a
cleaner without
removing from the
main unit.
(Do not wash.)
„
„ „
„ Sensitivity settings of the dust sensor
The sensitivity of the sensor differs depending on the size of
room, installation place, and type of dirt.
Change the sensor sensitivity if you don’t like it.
1. Press “ ” with the remote control pointed at the main
unit while holding “ ” on the main unit for
10 seconds.
• The receiving tone sounds, one of “ ” L (Low),
“ ” M (Standard) and “ ” H (High) lamps blinks for 5 seconds,
and then the lamp corresponding to the set sensitivity turns on.
2. Change the settings using the “ ” [Operation switch/
Stop] button of the main unit.
• Switches each time it is pressed.
• The settings is shown in the airflow rate indicator.
3. When you decide on the settings, point the remote
controller at the main unit and press the “ ”
[OFF TIMER] button.
• The receive sound will beep and the setting lamp will flash.
4. Unplug the power plug one time and then after
3 seconds or more plug it in again.
• This completes the settings.
NOTE
•
If the operation of 4 . is not performed, the unit will not return to
normal operation mode. If the operation of 4 . is performed, during
the settings, the settings will not be correct.
•
When the sensitivity is set high, it will become difficult for the sensor
lamp to go out.
„ „ „ „ Optional accessories
• For replacement pleated filter and bio-antibody filter, contact your
dealer.
• If used with dirty parts;
• Cannot obtain air clean effect.
• Cannot obtain deodorization effect.
• Odor may arise.
„ „ „ „ Disposal requirements
Your Daikin product is marked with this symbol. This
means that electrical and electronic products shall not
be mixed with unsorted household waste.
Disposal of this product must be done in accordance
with relevant local and national legislation. By disposing
of this product correctly, you will help ensure its proper
treatment, recovery and recycling, thus preventing
potential negative consequences for the environment and human
health. Please contact your local authority for more information.
Batteries must be removed from the remote controller and disposed of
separately in accordance with relevant local and national legislation.
Airflow speed
display
Dust sensor
sensitivity
High
(Sensor display
becomes easy
to light.)
Normal
(setting when
shipped)
Low
(Sensor display
will have difficulty
coming on.)
“ ”
L (Low)
“ ”
M (Standard)
“ ”
H (High)
Off timer button
Operation switch /
stop button Airflow rate indicator
Part name Part number
Pleated filter
(7 sheets)
KAC972A4E
Bio-antibody filter
(1 sheet)
KAF972A4E
01_EN_3P167171-1A.fm Page 15 Tuesday, October 18, 2005 4:14 PM