Daikin MC55VBFVM3, Руководство по эксплуатации

Страница: 16 / 56

15
Advanced Settings
When the sensitivity of the dust/PM2.5 sensor does not meet your preferences
*Setting at time of purchase
Setting Dust/PM2.5 Sensor Sensitivity
High Normal* Low
Setting procedures Remote controller Unit
1.
Hold down on the unit for about 5 seconds and when a short beep sounds, press on the
remote controller while pressing
on the unit.
• This setting change can be performed when the unit is on or off.
2.
Release both buttons when a short beep sounds.
• One of the FAN lamps ( (Low), (Standard), (Turbo)) will blink for about 5 seconds and then the lamp
corresponding to the currently set sensitivity will light up.
3.
Press on the unit to change the sensitivity setting.
• Each press cycles between the FAN lamps allowing you to change the sensitivity.
To set sensitivity High
Select the FAN lamp (Turbo).
The sensor is
highly receptive.
Setting at time
of purchase
The sensor is
slightly receptive.
(Standard)
(Turbo)
(Low)
High
Normal
Low
To set sensitivity
Low
Select the FAN lamp (Low).
• Setting is indicated using the FAN lamps. If the FAN lamp does not change, unplug the unit, wait at least 5 seconds, then
reinsert the power supply plug and repeat the above procedure from the beginning.
4.
Press on the remote controller after selecting the new setting.
• A short beep sounds and the new setting will blink. Unplug the unit while the lamp is blinking, wait at least 5 seconds,
and then reinsert the power supply plug. Setting is now complete.
• If this procedure is not performed, the unit will not return to regular operation mode.
Note
• Settings are remembered even if the unit is unplugged.
High Normal* Low
Advanced Settings
01_EN_3P549981-1C.indd 15 2020/04/17 16:24:47