Daikin IOM 1177-1, Установка, эксплуатация и обслуживание, Страница: 5 / 8

IOM 1177-1 / LIAF184 / Page 5 of 8
Installation
Field Wiring
Wiring between the sensor and the water source heat pump
unit for typical heating and cooling operation is shown in
Figure 3 .
Figure 3: Field wiring
SmartSource ™ Board
MicroTech
®
III Board
Base Board
Terminal Block Label TB1-1 TB1-2 TB1-3 TB1-4 TB1-5 TB3-1 TB3-2
Description
Unit Status Output
Fan & Unit Mode
Setpoint Adjust
Room
Temp
Sensor
&
Tenant Override
DC Signal Common
Emergency Shutdown
Input
Unoccupied Input
Terminal Label 1 2 3 4 5 E U
Typical Wiring
Terminal Label 1 2 3 4 5 E U
Description
Unit Status LED Input
Fan & Unit Mode
Setpoint Adjustment
Room
Temperature
Sensor &
Tenant Override
DC Signal Common
Emergency Shutdown
Unoccupied
Adjustable Cool/Warm Room Temperature Sensor with Occupancy Switch (Part No. 910121753)
Maintenance
Wipe the thermostat case as needed with a damp, water only
cotton cloth. Do not use any type of cleaner as it may damage
the buttons or labeling. Do not paint.
Terminal Descriptions
1 – Unit Status Indicator Input from the MicoTech III
SmartSource Unit Controller. (5VDC)
2 - Output Signal, Fan and Unit Mode (0 to 5VDC)
3 - Output Signal, Setpoint Adjustment
4 - Output Signal, Room Temp Thermistor Sensor. (10K ATP
Z curve, 10K-2)
5 - Ground or Neutral. Common Reference for All Signal
Terminals
E – Emergency Shutdown. (Terminal grounded when in
System “Off” mode)
U - Unoccupied Contact. (Terminal grounded when in
Unoccupied)