Daikin FT50GAVE, Руководство по эксплуатации

Страница: 9 / 18

8
Preparation Before Operation
Indoor unit
■
Setting the air purifying filters
1
Open the front grille.
●
Hold the grille by the tabs on the two
sides and lift it until it stops with a click.
(about 60°)
2
Pull out the air filters.
●
Push upwards the
tab at the center of
each air filter, then
pull it down.
3
Set the air purifying filters.
●
Attach an air purifying filter to each air
filter.
(See page 12 “Care and cleaning”)
4
Set the air filters in their original
positions and close the front grille.
●
Operation without air filters may result in
troubles as dust will accumulate inside
the indoor unit.
■
Setting the clock
1
Press .
AM
is displayed.
blinks.
2
Press
TIMER
to set the clock to the
present time.
●
Holding down ( ) or ( ) button rapidly
increases or decreases the time display.
3
Press .
blinks.
(Now the clock is set.)
■
Turn the breaker ON
●
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
AM
Display
PM
Display
PM
Display
NOTE
Tips for saving energy
●
Be careful not to cool the room too much.
Keeping the temperature setting at a
moderate level helps save energy.
Recommended temperature setting
For cooling: 26°C – 28°C
●
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling effect.
●
Clogged air filters cause inefficient
operation and waste energy. Clean them
once in about every two weeks.
Please note
●
The air conditioner always consumes 15 – 35
watts of electricity even while it is not operating.
●
If you are not going to use the air conditioner
for a long period, for example in spring or
autumn, turn the breaker OFF.
●
Use the air conditioner in the following conditions.
Mode
COOL
DRY
Operating conditions
Outdoor temperature : 19 to 46 °C
Indoor temperature : 18 to 32 °C
Indoor humidity
: 80% max.
Outdoor temperature : 21 to 46 °C
Indoor temperature : 18 to 32 °C
Indoor humidity
: 80% max.
If operation is continued out of this range
•
A safety device may work
to stop the operation.
(In multi system, it may
work to stop the operation
of the outdoor unit only.)
•
Condensation may occur
on the indoor unit and drip.
•
A safety device may work
to stop the operation.
•
Condensation may occur
on the indoor unit and drip.