• Be sure to switch off the unit before touching any electrical parts.
• Be sure to earth the air conditioner.
• Do not earth the unit to a utility pipe, lightning conductor or telephone earth lead. Imperfect earthing may
result in electric shocks or fire.
• A high surge current from lightning or other sources may cause damage to the air conditioner. Be sure to install an
earth leakage breaker.
• Failure to install an earth leakage breaker may result in electric shocks or fire.
• The appliance must be stored in a room without continuously operating ignition sources (for example: open
flames, an operating gas appliance or an operating electric heater). Do not pierce or burn.
• Floor area required for installation of the equipment, read this installation manual thoroughly.
-&
CAUTION------------------------
•
While following the instructions in this installation manual, install drain piping to ensure proper drainage and
insulate piping to prevent condensation.
•
Improper drain piping may result in indoor water leakage and property damage.
•
Install the indoor and chiller, power cord and connecting wires at least 1 meter away from televisions or radios
to prevent picture interference and noise.
•
(Depending on the incoming signal strength, a distance of 1 meter may not be sufficient to eliminate noise.)
Remote controller (wireless kit) transmitting distance can be shorter than expected in rooms with electronic
fluorescent lamps (inverter or rapid start types). Install the indoor unit as far away from fluorescent lamps as
possible.
In a domestic environment this product may cause radio interference in which case the user may be required
to take adequate measures.
Make sure to provide for adequate measures in order to prevent that the chiller unit be used as a shelter by
small animals. Small animals making contact with electrical parts can cause malfunctions, smoke or fire.
•
Please instruct the customer to keep the area around the unit clean.
Install in a machine room that is free of moisture. The unit is designed for indoor use.
Dismantling of the unit, treatment of the oil and of other parts must be done in accordance with relevant local
and national legislation.
Do not install the air conditioner in the following locations:
1. Where there is a high concentration of mineral oil spray or vapour (e.g. a kitchen). Plastic parts will deteriorate,
parts may fall off and water leakage could result.
2. Where corrosive gas, such as sulphurous acid gas, is produced.
3. Corroding of copper pipes or soldered parts may result in water leakage.
4. Near machinery emitting electromagnetic radiation.
5. Electromagnetic radiation may disturb the operation of the control system and result in a malfunction of the unit.
6. Where flammable gas may leak, where there is carbon fiber or ignitable dust suspensions in the air, or where
volatile flammables such as paint thinner or gasoline are handled. Operating the unit in such conditions may
result in fire.
3
