D-EIMWC01206-15EN - 5/20
Noise
The noise generated by the unit is mainly due to the
rotation of compressors.
The noise level for each model size is listed in sales
documentation.
If the unit is correctly installed, operated and maintained
the noise emission level do not require any special
protection device to operate continuously close to the
unit without any risk.
In case of installation with special noise requirements it
could be necessary to install additional sound
attenuation devices.
Handling and lifting
The unit must be lifted with the utmost care and
attention, following the lifting instructions shows on the
label applied to the electric panel. Lift the unit very
slowly, keeping it perfectly level.
Avoid bumping and/or shaking the unit during the
handling and loading/unloading operations from the
transportation vehicle, push or pull the unit only using
the base frame. Secure the unit inside the truck to
prevent it from moving and causing damages. Do not
allow any part of the unit to fall during
loading/unloading.
All units have lifting points marked in yellow. Only these
points may be used for lifting the unit, as shown in the
following figure. The handling and lifting with a fork lift is
the only alternative method.
Both the lifting ropes and the spacing bars must
be strong enough to support the unit safely. Check
the weight of the unit on its name plate, because
the weight of the units varies depending on the
accessories requested.
Figure 3 - Handling of the single circuit unit
Alternative handling method
