Daikin ETVX16E6V7, Руководство по установке

Страница: 20 / 40

7 Configuration
Installation manual
20
ETVH/23E
Daikin Altherma 3 H HT F
4P644728-1D – 2022.08
B
A
B
X5M
1 2 3 4
X10M
4 Fix the cables with cable ties to the cable tie mountings. If
necessary, bundle excessive cable length with a cable tie.
6.3.12 To connect the WLAN cartridge (delivered
as accessory)
[D] Wireless gateway
1 Insert the WLAN cartridge into the cartridge slot on the user
interface of the indoor unit.
1
2
6.4 After connecting the electrical
wiring to the indoor unit
To prevent water ingress to the switch box, seal the low voltage
wiring intake using the sealing tape (delivered as accessory).
Without low voltage cables With low voltage cables
7 Configuration
INFORMATION
Cooling is only applicable in case of reversible models.
7.1 Overview: Configuration
This chapter describes what you have to do and know to configure
the system after it is installed.
NOTICE
This chapter explains only the basic configuration. For
more detailed explanation and background information,
see the installer reference guide.
Why
If you do NOT configure the system correctly, it might NOT work as
expected. The configuration influences the following:
▪ The calculations of the software
▪ What you can see on and do with the user interface
How
You can configure the system via the user interface.
▪ First time – Configuration wizard. When you turn ON the user
interface for the first time (via the unit), the configuration wizard
starts to help you configure the system.
▪ Restart the configuration wizard. If the system is already
configured, you can restart the configuration wizard. To restart the
configuration
wizard, go to Installer settings >
Configuration wizard . To access Installer settings , see
"7.1.1 To access the most used commands" [
4
20].
▪ Afterwards. If necessary, you can make changes to the
configuration in the menu structure or the overview settings.
INFORMATION
When the configuration wizard is finished, the user
interface will show an overview screen and request to
confirm. When confirmed, the system will restart and the
home screen will be displayed.
Accessing settings – Legend for tables
You can access the installer settings using two different methods.
However, NOT all settings are accessible via both methods. If so,
the corresponding table columns in this chapter are set to N/A (not
applicable).
Method Column in tables
Accessing settings via the breadcrumb in the
home menu screen or the menu structure .
To enable breadcrumbs, press the button
in the home screen.
#
For example: [2.9]
Accessing settings via the code in the
overview field settings .
Code
For example: [C-07]
See also:
▪ "To access the installer settings" [ 4 21]
▪ "7.5 Menu structure: Overview installer settings" [
4
29]
7.1.1 To access the most used commands
To change the user permission level
You can change the user permission level as follows:
1 Go to [B]: User profile .
User profile
B
2 Enter the applicable pin code for the user permission
level. —
▪ Browse through the list of digits and change the
selected digit.
▪ Move the cursor from left to right.
▪ Confirm the pin code and proceed.