Daikin DWSC - Vintage C, Руководство по эксплуатации

Страница: 24 / 39

D-EOMWC00803-26_01EN - 24/39
4.7 Unit Mode
This item shows the present Operating Mode and jumps to the page for unit mode selection.
Setpoint/Sub-Menu Default Description
Available Modes= Cool Cool,
Cool w/ Glycol,
Cool/Ice w/Glycol,
Ice w/Glycol,
Heat/Cool,
Heat/Cool w/Glycol,
Heat/Ice w/Glycol,
Pursuit,
Test Available operating modes
Depending on selected mode among availables, the Unit Mode on the main menu will assume the corresponding value
according to the following table:
Available mode selected
C/H Switch = Cool C/H Switch = Heat
Cool
Cool
N/A
Cool w/ Glycol
Cool/Ice w/ Glycol
Ice w/ Glycol
Ice
Heat/Cool
Cool
Heat Heat/Cool w/Glycol
Heat/Ice w/Glycol
Ice
Pursuit Pursuit
Test Test
4.8 Unit Enable
This page allows to enable or disable unit and circuits. For the unit it also possible enable the operation with time scheduler,
while for circuit it is possible to enable the test mode.
Setpoint/Sub-Menu Default Range Description
Unit Enable Enable, Disable, Scheduler Unit enable command
Compressor 1 Enable Enable, Disable, Test Compressor #1 enable command
Compressor 2 Enable Enable, Disable, Test Compressor #2 enable command
4.9 Timers
This page indicates the remaining cycle timers for each circuit and the remaining staging timers. When the cycle timers
are active any new start of a compressor is inhibited.
Setpoint/Sub-Menu Default Range Description
Cmp1 Cycle T Left 0s - Compressor 1 cycle timer
Cmp2 Cycle T Left 0s - Compressor 2 cycle timer
Cmp1 Cycle T Clr Off Off, On Clear compressor 1 cycle timer
Cmp2 Cycle T Clr Off Off, On Clear compressor 2 cycle timer
Stg Up Dly Rem 0s - Remaining delay to next compressor start
Stg Dn Dly Rem 0s - Remaining delay to next compressor stop
Clr Stg Delays Off Off, On Clear remaining delays to next compressor start/stop
4.10 Alarms
This link jumps to the same page accessible with the Bell button. Each of the items represents a link to a page with different
information. The information shown depends on the abnormal operating condition that caused the activation of unit, circuit
or compressor safeties. A detailed description of the alarms and how to handle will be discussed in the section 4.11.1.
Setpoint/Sub-Menu Default Description
Alarm Active

List of the active alarms
Alarm Log

History of all the alarms and acknowledges
Event Log

List of the events
Snapshot

List of alarm snapshots with all the relevant data recorded at time the alarm occurred.
Advanced

Submenu for snapshot sd exporting