![background image](http://html1.mh-extra.com/html/daikin/dbc0363b-series/dbc0363b-series_installation-instructions-manual_2460477006.webp)
6
5
6-3/16
7-3/8
SUPPLY
12" X 17"
RETURN
11" X 25"
Horizontal Discharge Duct Connections
RIGGING DETAILS
WARNING
To prevent property damage, the unit should remain
in an upright position during all rigging and moving
operations. To facilitate lifting and moving when a
crane is used, place the unit in an adequate cable sling.
CAUTION
If units are lifted two at a time, the fork holes on the
condenser end of the unit must not be used. Minimum
fork length is 42” to prevent damage to the unit;
however, 48” is recommended.
Provisions for forks have been included in the unit
base frame. No other fork locations are approved.
WARNING
To prevent possible equipment damage, property
damage, personal injury or death, the following bullet
points must be observed when installing the unit.
•
Unit must be lifted by the four lifting holes located at
the base frame corners.
•
Lifting cables should be attached to the unit with shackles.
•
The distance between the crane hook and the top of
the unit must not be less than 60”.
•
Two spreader bars must span over the unit to
prevent damage to the cabinet by the lift cables.
Spreader bars must be of sufficient length so that
cables do not come in contact with the unit during
transport. Remove wood struts mounted beneath
unit base frame before setting unit on roof curb.
These struts are intended to protect unit base frame
from fork lift damage. Removal is accomplished by
extracting the sheet metal retainers and pulling the
struts through the base of the unit. Refer to rigging
label on the unit.
Important: If using bottom discharge with roof
curb, ductwork should be attached to the curb
prior to installing the unit. Ductwork dimensions
are shown in Roof Curb Installation Instructions.
Refer to the Roof Curb Installation Instructions for proper
curb installation. Curbing must be installed in compliance
with the National Roofing Contractors Association Manual.
To assist in determining rigging requirements, unit weights
and center of gravity are shown as follows:
Y
X
CG
COMPRESSOR
CONDENSER COIL
RETURN
EVAPORATOR COIL
B
C
D
A
SUPPLY
Corner and center of gravity locations
Note: Unit should be lifted at a point above center
of gravity.
Weights for DBC/DBH Direct Drive models
MODEL
Shipping
Weight
(lbs)
Operating
Weight
(lbs)
Corner Weights
(lbs)
Length Width
A B
C D
X (in) Y (in)
DBC0363B* 619
573
96 207 147
123
34.8
27.8
DBC0483B* 644
598
95 225 150 128 34.3
28.5
DBC0484B* 646
600
105
219
144
132
33.9
28.3
DBC0603B* 688
642
117 227 136 162 34.3
29.3
DBH0363B* 651
605
156 165
112
172 34.6
27.1
DBH0364B* 656
610
140 180 148 142 35.2
26.8
DBH0483B* 686
640
121
224 150 145 34
27.8
DBH0484B* 688
642
131 213
142 156 34.3
27.8
DBH0603B* 732
686
234 150 73
229
32.5
26.7
DBH0604B* 739
693
108 270 186
129
33.5
27.8
DBC0723V* 724
678
141
219
72 246 34.6
27.6
The numbers may slightly vary depending on
installed options.